what is toroid.................?????????????????????????

sreekanth sree, 8 years ago

Grade:12

12 Answers

Gowri sankar

292 Points

8 years ago

DEAR SREEKANTH, A SOLENOID WHEN IN THE FORM OF A CCIRCLE SUCH THAT IF TWO ENDS MEET IS CALLED TOROID.................................................

Disapproved

Prabhakar ch

577 Points

8 years ago

Dear Sreekanth A toroid is a coil of insulated or enameled wire wound on a donut-shaped form made of powdered iron. A toroid is used as an inductor in electronic circuits, especially at low frequencies where comparatively large inductances are necessary.

N JYOTHEESWAR

342 Points

8 years ago

a toroid is a insulated or coiled wouned on a downuted shape fo

Gaddam Chethan

317 Points

8 years ago

Hello Sreekanth:The definition of a toroid is a doughnut-shaped object that is formed by a curved surface, shape or body that rotates around a center point without intersecting it.

RAMCHANDRARAO

159 Points

8 years ago

A SOLENOID BEND IN THE FORM OF A CIRCLE SUCH THAT ITS TWO ENDS MEET IS CALLED TOROID

ALL THE BEST FOR YOUR BRIGHT FUTURE

mohan

216 Points

8 years ago

dear iitian.......a toroid is a surface of revolution with a hole in, like a doughnut. The axis of revolution passes through the hole and so does not intersect the surface. For example when a rectangle is rotated around an axis parallel to one of its edges, then a hollow square-section ring is produced.

T.kumar

281 Points

8 years ago

dear srikanth... torid is defined

sudarshan

174 Points

8 years ago

SAI SARDAR

1700 Points

8 years ago

Srrekanth,Toroid is a coil of insulated in a circle with radius r.Such that the two ends are meeting at a point.

Approved

raj

383 Points

8 years ago

A toroid is a coil of insulated or enameled wire wound on a donut-shaped form made of powdered iron and a doughnut-shaped object that is formed by a curved surface, shape or body that rotates around a center point without intersecting it. Toroid is a coil of insulated in a circle with radius r.Such that the two ends are meeting at a point.