A student measured the diameter of a small steel ball using a screw gauge of least count 0.001cm. The main scale reading is 5 mm and zero of circular scale division coincides with 25 divisions above the reference level . If the screw gauge has a zero error of -0.004 cm,then what is the correct diameter of the ball?

moment of inertia of a equilateral triangle about an axis passing through centre and perppendicular to the plane

. Because of the rotation of the earth, a plumb bob may not hang exactly along the direction of
the earth’s gravitational pull (its weight) but deviates slightly from this direction. Calculate the
deviation (a) at 40 latitude, (b) at the poles, and (c) at the equator

The length of a massless rod is measured using vernier callipers having 10 vernier scale divisions and least count of 0.1 mm. Two masses 1.00 ± 0.01 kg and 4.00 ± 0.02 kg are attached to its ends. If reading of vernier scale is 5 divisions coinciding with 1.3 cm, what is the % error in locating centre of mass from lighter mass

A block is kept on x-y plane at a point (2m,3m). It is pushed with a force of magnitude 10 Ntowards point (5m,7m). The force can be represented as?